This salt mist corrosion test chamber is suitable for accelerating salt mist corrosion test of industrial products such as electronic devices, product parts, protective layer of metal materials, etc.
-
Salt mist corrosion test chamber
-
Temperature uniformity measurement
The device could cyclically scan the temperature of each channel.
-
Soldering Peel Tester
Meet the Peel test strength test requirements in MST 35 & Lap shear strength test requirements in MST36 clause of the IEC61730-2:2016 standard. Also, the tester could be used in soldering peel t
-
Accessibility tester
Meet the accessibility test test requirement specified in MST11 clause of the IEC 61730-2:2016 standard.l Could test the ohm value;l Could check the press value;l The resistance value could b
-
Power supply for TC & HF(UL standard)
Meet the Thermal cycling test(TC) requirements specified in the 4.11 clause of IEC 61215-2016 standard & MST51 clause of & IEC61730-2016 standard & 35 clause in UL1703 standard. Meet the H
-
Outdoor test system
Meet the Stability test requirements specified in 4.19(MQT19) clauses of IEC 61215:2016 standards. The system is designed for 10 pcs modules. Meet the Outdoor exposure test requirements specified in 4
-
Sun Simulator Pulsed type
This equipment is designed for testing the power and IV curve of solar module. The radiation class could meet 3A+ level specified in IEC60904-9 standards. It could be used to test silicon cell, thin f
-
System voltage durability tester
Meet the test requirements for the voltage withstanding and insulation resistance of solar modules specified in 4.3 clause of IEC 61215-2016 and MST16 in IEC 61730-2016.l Provide stable voltage for
-
Universal material tester
Meet the Lap shear strength test in MST 36 clause of the IEC61730-2:2016 standard and other force test.l Pulling clamp could be controlled moving vertically and the moving speed could be set.l T
-
Spray test machine
Meet the spray test requirements in 33 clause of the UL 1703 standard.l The transparent full-closed test device can not only observe the conditions during the test, but also prevent water droplets
-
Drop-Ball Impact Tester
The equipment is used to drop ball to impact some material. l Automatic raising and lowering function of ball pickup arml Indicator light display the steel ball reaching the corresponding height
-
Push tester
The PV module push tester is to apply a certain force to a certain point on the surface of the module, so as to evaluate the performance of the module thrust resistance. Meets the Push test conditions
-
Terminal box knock out tester
Meets the Terminal box knock out test requirements specified in the MST44 clause of the IEC 61730-2:2004 standard.l With special fixture for junction box;l Time relay could programmed to contro
-
Sharpness of edge determination equipment
This product is used to determine whether there is dangerous sharp edge of unreasonable injury on the edge of toys or articles. Meets the sharp edge test conditions in IEC 61730-2:2016、UL1439-2004、U